Toyota 90919-01217 Plug, Spark

You can Select Your Vehicle to check if 90919-01217 fits your vehicle.

Proper maintenance of spark plugs is essential for the engine's correct operation and efficiency. Using spark plugs appropriate for the engine type as specified in the Vehicle Emissions Control Information (VECI) label under the bonnet or the Owner's Handbook is crucial. In general, if the correct type is used and the engine is in good condition, spark plugs shouldn't require attention between scheduled maintenance intervals. Cleaning spark plugs is rarely necessary and should be done with specialized equipment to avoid damaging the firing ends. To replace them, remove the four ignition coils in vehicles equipped with a direct ignition system (DIS). Spark plugs are recessed deeply in the engine, requiring a 16 mm spark plug socket and extension bar for access. Using ordinary deep sockets is not advisable. Care should be taken to prevent dirt from entering the cylinders when removing the spark plugs, although it can be challenging due to the deep recesses. Examine each plug as it's removed to assess the engine's condition based on deposits and insulator appearance. The spark plug electrode gap is critical, and it should be set to the specified value. Be cautious not to bend the center electrode when adjusting the gap, and special tools are available for this purpose. Before installation, ensure the spark plug's threaded connector sleeves are tight and the plug is clean. Tighten the spark plugs to the specified torque using a torque wrench and a spark plug socket, then refit the ignition coils, air cleaner, and inlet duct.

You will need a spark plug socket with a rubber grommet, a wire-type feeler gauge, and a torque wrench.

Repeat the process for the remaining spark plugs.

Spark plug replacement requires a spark plug socket lined with a rubber grommet, a ratchet wrench, a wire-type feeler gauge, and a torque wrench. To replace the plugs, purchase the correct ones for your vehicle and adjust them to the proper gap. Inspect the new plugs for defects and check the electrode gaps using a wire gauge. Remove the ignition coils and blow away any dirt or foreign material. Use a special spark plug socket to remove the old plugs. Compare the old plugs to a chart to determine the engine's condition. Prior to installation, coat the spark plug threads with anti-seize compound and use a length of rubber hose to help align the plug and prevent cross-threading. Finally, tighten the plug and install the ignition coils.