Toyota 35330-0C010 STRAINER Assembly, Oil

You can Select Your Vehicle to check if 35330-0C010 fits your vehicle.

Underneath the transmission pan.

At the specified intervals, the transmission fluid should be drained and replaced. Since the fluid will remain hot long after driving, perform this procedure only after the engine has cooled down completely. Before beginning work, purchase the specified transmission fluid and a new filter. Other tools necessary for this job include a floor jack, jackstands to support the vehicle in a raised position, a drain pan capable of holding at least eight quarts, newspapers and clean rags. Raise the vehicle and support it securely on jackstands. Place the drain pan underneath the transmission pan and remove the drain plug. Allow the fluid to completely drain from the transmission, then reinstall the drain plug. Detach the transmission pan rock shield (if equipped) and remove the pan mounting bolts from the outer edges of the pan. Using a rubber mallet, carefully tap on the pan to break the layer of gasket sealant between the pan and the transmission case. Lower the pan and drain any remaining transmission fluid from the pan. Remove the filter retaining bolts from the valve body and remove the filter, then remove the O-ring from the valve body. Thoroughly inspect the bottom of the pan, the filter, and the fluid. Clean the pan with solvent and dry it. Use a gasket scraper to remove any traces of old gasket material remaining on the transmission case or valve body. Install a new O-ring on the filter, then install the filter, tightening the bolts. Be sure the gasket surface on the transmission pan is clean, then install the gasket to the oil pan. Place the pan against the transmission case and, working around the pan, tighten each bolt a little at a time. Check under the vehicle for leaks during the first few trips. Check the fluid level again when the transmission is hot.