Genuine Toyota 4Runner Automatic Transmission Filter

Toyota 4Runner Automatic Transmission Filter Parts Questions & Answers

• Strainer Assy, Valve Body Oil
  35330-30011
  Q: How to drain and replace transmission fluid and Filter at specified intervals on Toyota T100,Toyota 4Runner and 1995 through 2004 Toyota Tacoma?

  A: After the engine cools, purchase the correct transmission fluid and a new filter. You'll need a floor jack, jackstands, a drain pan, newspapers, and rags. Raise the vehicle and place the drain pan under the transmission. Remove the drain plug, let the fluid drain, then reinstall the plug. Remove the transmission pan and drain remaining fluid. Remove the filter. Inspect the pan, filter, and fluid. Clean the pan and remove old gasket. Install a new filter and gasket. Apply sealant to the pan and reinsert the filler tube. Reattach the pan. Lower the vehicle, add fluid, and run the engine. Move the gear selector through each range. Check the fluid level and add more if needed. Check for leaks and the fluid level when hot.
• Strainer Assy, Valve Body Oil
  35330-60050
  Q: How to change the transmission fluid and Automatic Transmission Filter on Toyota 4Runner without a dipstick?

  A: For 2005 and later models without a dipstick, change the transmission fluid every 60,000 miles under severe conditions. After the engine cools, buy the specified fluid and a new filter. You'll need a floor jack, jackstands, a drain pan, newspapers, and rags. Raise the vehicle and place the drain pan under the transmission pan. Remove the drain plug, let the fluid drain, and reinstall the plug. Remove the pan rock shield and bolts. Break the gasket seal and lower the pan. Separate the dipstick tube parts and drain remaining fluid. Remove the filter retaining bolts and filter. Check the pan, filter, and fluid for damage. Clean the pan and remove old gasket material. Install new gaskets, apply RTV sealant, and reinsert the filler tube. Tighten the bolts and lower the vehicle. Add 1-1/2 quarts of fluid, start the engine, and move the gear selector. Check the fluid level and add as needed. Check for leaks and fluid level when hot.