A: Start by loosening wheel bolts, raising the vehicle, and removing the wheel. Remove rear coil spring, suspension air bags, brake caliper, bracket, and disc. Remove the rear wheel speed sensor, harness, grease cap, and driveaxle/hub nut. Disconnect the upper Control Arm and remove the hub/bearing assembly. Replace the O-ring on the hub. To install, lubricate the driveaxle splines, place the hub/bearing assembly onto the knuckle, and tighten bolts. Install the knuckle and a new driveaxle/hub nut. Tighten all fasteners, install the wheels, lower the vehicle, and tighten the driveaxle/hub bolt and lug nuts.
Q: How do I remove the front hub/bearing assembly?
A: Remove the dust cover and loosening the drive axle/hub nut on 4WD models. Loosen wheel bolts, raise the vehicle, and remove the wheel. Remove the brake caliper, bracket, and disc, supporting the caliper with wire. Remove the hub/bearing assembly bolts and take out the assembly. Replace the O-ring on the hub. For bearing replacement, consult a professional. Ensure the mounting surfaces are smooth for installation. For 2WD models, install the assembly to the knuckle. For 4WD models, lubricate the drive axle splines and place the assembly onto the knuckle. Install a new drive axle/hub nut but don't tighten it yet. Install the brake disc, bracket, and caliper.