To source the hazard warning switch, first of all, it is required to disassemble the center trim side finish panel of the instrument panel. Carefully twist the clips to release the switch housing and unsnap it from the switch, remove the tab connector on the back of the switch. Removal or Installation is basically the opposite of the other; it entails the act of putting in something or a method used in fastening of items. With regard to the power mirror control switch, starting with the removal of the fuse box cover, the electrical connector should also be removed before pushing the switch out of the panel. Similar to the case with removal, installation is also the opposite of removal. These finishes comprise the HVAC controls, defogger switch assembly, and the designs that are fixed on the instrument panel; they must be detached cautiously so that their links with the center cluster finish panel can be severed. Pop off the clips of the HVAC control assembly and remove electrical connectors at the back of switch without straining the wire harnesses. In installation, it happens in a reverse order, that is, the last thing that has been installed must be the first thing to be removed. To dismantle this system, one is required to pry the switch for the instrument panels rheostats and disconnect the electrical connector for the switch for the removal of the switch, the procedure of fitting in is the reverse of the removal process. These include the console switches and power outlet switches and the procedure involves; gently removing the switch panel from the instrument panel, remove the electrical connector and push the switch out of the panel while the putting in of the switch entails the reverse process. Regarding the power outlet, it is done in the similar sequential manner however after reaching for the power outlet remove the electrical connector then push the outlet through the panel and the process of installation will be as follows but in the reverse order. All in all, for the engine start/stop switch in Smart Key models, the instructions are as follows: Disconnected the cable from the negative terminal, denounced the heater and air conditioning control assembly, denounced the engine switch wiring harness connectors, pull the two retaining clips back and extract the switch out from the control assembly, for installation, reverse the steps stated above.