My Garage
My Account
Cart
Genuine Toyota Solara Fuel Door Release Cable
Gas Door Safety Release Cable- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
3 Fuel Door Release Cables found
Toyota Solara Fuel Lid Lock Control Cable Sub-Assembly
Part Number: 77035-06080$44.73 MSRP: $62.53You Save: $17.80 (29%)Ships in 1-3 Business Days
Toyota Solara Fuel Door Release Cable
The driver can pop the gas door from inside the cabin with a quick pull of the Toyota Solara Fuel Door Release Cable. This saves the trouble of awkwardly prying it from the exterior panel. The Fuel Door Release Cable runs from the pull lever beside the seat to the latch behind the small square door. The cable consists of a braided wire encased in a protective sleeve that slides in and out smoothly when a pull is made on it. This lifts a latch tab that makes the door spring open. In the event that the wire frays or snaps, the Toyota driver must exit the vehicle and is likely to find the door impossible to open. Therefore, a new Fuel Door Release Cable needs to be installed at the first sign of sticking or requiring extra force. First and second-generation Solara coupe and convertible use the same single-strand steel design, which changed from early plastic end clips to more robust metal clips, a minor difference that should make replacing worn Fuel Door Release Cable a bit easier for newer cars. All Toyota versions route the line under the trunk trim and then under the carpet to the seat-side lever. Likewise, all Solara models still rely on rust-free hinges in order to benefit from a responsive Fuel Door Release Cable.
If you are in demand for superior quality and affordable OEM Toyota Solara Fuel Door Release Cable, then shop with us! We own a wide range of the reduced-priced genuine Toyota Solara Fuel Door Release Cable. You can purchase in confidence as all parts come with a manufacturer's warranty. Any issues with our products? No need to worry as we have a hassle-free return policy to guide you every step of the way.
Toyota Solara Fuel Door Release Cable Parts Questions & Experts Answers
- Q: How to remove and install the Fuel Door Release Cable on a 2002 through 2008 Toyota Solara?A:During Solara fuel door and trunk release cable work, you must take apart and put back both cables at the same time. Begin by removing the trunk latch. To get to the Fuel Door Release Cable end, pull the left-side panel and floor mat inside the trunk. Push and turn the tabs on the Fuel Door Release Cable end to unlock it from the fuel door housing. Then pull it straight until it releases. To free the cable end retainer, you need to twist it out of its bracket. First, get rid of the rear seat bottom. For coupes, you'll have to eliminate both seat back and bottom at the same time. Men working on the driver's side door sill covers will find only one cover for coupes and need to remove the trim piece attached to the center door pillar when working on four-door cars. Pull up the carpeting to reach the release cable, then detach it from all the clips stuck to the car's body. Unscrew the bolt holding the release handle's base to the floor by pulling apart the carpet's small opening. Pull off the housing parts to take out the cable holders and eyes from their levers. In the trunk space, thread wire through the cable end, then use the wire to pull the entire cable rearward until it's visible. To finish up, connect the wire to the front end of the new cable, and send it back through the body by pulling, until you can affix it to the lever. This ends the replacement process.
