Genuine Toyota Solara Fuel Level Sensor

Toyota Solara Fuel Level Sensor Parts Questions & Answers

• Gage Assy, Fuel Sender
  83320-33030
  Q: How to check, remove, and install the fuel level sending unit on 1997 through 2001 Toyota Avalon and 1997 through 2001 Toyota Solara?

  A: To check the fuel level sensor, relieve fuel system pressure and disconnect the negative battery cable. Remove the Fuel Pump/fuel level sensor from the Fuel Tank. Disconnect the sensor connector and use an ohmmeter to check resistance while moving the float arm. Resistance should be around 110-115 ohms when the tank is empty and 2-3 ohms when full, with a smooth transition in between. If readings are incorrect, replace the sensor. For removal, carefully angle the sensor out of the opening without damaging the fuel level float and disconnect electrical connectors. Remove mounting screws and separate the sensor from the assembly. Installation is the reverse of removal.
• Gage Assy, Fuel Sender
  83320-33030
  Q: How to remove and install the fuel pump/fuel level sending unit assembly on 2002 through 2008 Toyota Solara and 2002 through 2006 Toyota Avalon?

  A: Relieve the fuel system pressure, then disconnect the negative battery cable. Remove the Fuel Pump/fuel level sending unit assembly from the Fuel Tank. Carefully angle the sending unit out of the opening without damaging the fuel level float located at the bottom of the assembly. Disconnect the electrical connector from the sending unit. Pry the sending unit from the retaining clips. Disconnect the electrical connector and pry the fuel level sending unit from the clips and separate it from the assembly. Installation is the reverse of removal.