Unplug the cable from the battery's negative end, and remember to turn off the anti-theft audio system lockout if it exists. Remove the center cluster finish bezel. Remove the bolts holding the radio in place at the instrument panel. Pull out the radio, then disconnect the wiring that runs to the
Antenna and instrument panel. To install the radio, do the opposite of how you took it out - first remove, then install. Each vehicle has at least one speaker in every door, and T100 models add the same mounted in speaker grills above and below each door, while T100 trucks with rear seating saddle two more speakers back there. To take out speakers from the car doors, remove the door panels first, pull off the screws holding the speakers, and disconnect the electrical cable. To take out the back speaker on a T100, detach the speaker box, disconnect its electrical wire, and unscrew the speaker keeping screws from their holes. Installation is the reverse of removal.