Toyota 27060-0P140 Alternator Assembly

Disconnect the cable from the negative battery terminal. For four-cylinder engines, raise the vehicle and support it securely on jack stands. Remove the drive belt, detach the electrical connectors from the alternator, and remove the alternator mounting bolts and harness clamps. Remove the alternator from the mounting bracket. For V6 engines, loosen the right-front wheel lug nuts, then raise the vehicle and support it securely on jack stands. Remove the right front wheel, lower engine cover(s), fender inner liner, drive belt, upper engine covers, air cleaner and inlet assembly, and front bumper assembly. Drain the engine coolant and remove the coolant expansion tank mounting fasteners. Set the tank to the side and remove the radiator. Detach the electrical connectors from the alternator, remove the alternator mounting bolts and harness clamps, and remove the alternator from the mounting bracket. If replacing the alternator, ensure the new unit is identical to the old one in terms of terminals and identification markings. Install the pulley if necessary. Reverse the removal steps and check the charging voltage to verify proper operation of the alternator.

To remove the alternator, first detach the cable from the negative terminal of the battery, then remove the drivebelt. Next, detach the electrical connectors from the alternator and the electrical harness that goes over it. Remove the two bolts securing the alternator, and for V6 models, loosen the alternator adjustment bolt to take off the drivebelt before removing the two alternator mounting bolts. If replacing the alternator, take the old unit when purchasing a new or rebuilt one, ensuring it is identical in terms of terminal number, size, and location, as well as matching identification markings. Many new or rebuilt alternators may not come with a pulley, so check the shop's policy on switching pulleys from the old unit. Installation follows the reverse order of removal, and after installation, adjust the drivebelt tension and check the charging voltage to ensure the alternator operates correctly.

Disconnect the cable from the negative battery terminal.

it is complete assembly