Toyota 27060-0S020 Alternator Assembly

You can Select Your Vehicle to check if 27060-0S020 fits your vehicle.

To remove the alternator, start by disconnecting the cable from the negative battery terminal. For VG engines, remove the battery and engine cover, followed by the lower splash shield and drivebelt. On 2011 and later models, remove the idler pulley center bolt and pulley. Then, remove the wiring harness clamp bolt and disconnect the electrical connectors to the alternator. Remove the upper and lower alternator mounting bolts and lift the alternator from the engine. On VB engines, remove the engine cover and loosen the right-front wheel lug nuts. Raise the front of the vehicle and remove the drivebelt. Remove the air filter inlet duct and, on certain models, the air filter housing. Drain the cooling system and remove the radiator hoses and cooling fan and shroud on Sequoia models. Remove the right front wheel and the plastic clips from the rubber seal on the inner fender well splash shield. Remove the power steering pump and disconnect the electrical connectors from the alternator. Remove the alternator mounting bolts and nut. To install the alternator, ensure that the replacement unit is identical to the old one in terms of terminals and identification markings. If necessary, switch the pulley from the old unit to the new one. Finally, installation is the reverse of removal.

This alternator produces 150 amps

yes bushings no cover part of the wiring and harness.