Toyota 48815-0C050 Bush, Front STABILIZER Bar

You can Select Your Vehicle to check if 48815-0C050 fits your vehicle.

Raise the vehicle and support it securely on jackstands. Remove the nuts from the sway bar kit links and detach the links from the bar. Also remove the bolts attaching the links to the lower control arms, then remove the links. Remove the sway bar bushing bracket nuts or bolts. Remove the sway bar kit. Remove the rubber bushings from the sway bar kit. Inspect the rubber bushings for cracks, tears and deterioration. If they're worn or damaged, replace them. Check the balljoint on the lower end of each link for looseness or other signs of excessive wear. You can check the rotational torque required to turn the balljoint by threading the nut onto the ballstud and turning it with an inch-pound torque wrench. When you install the rubber bushings on the sway bar kit, position them so the slits face toward the front of the vehicle. Installation is otherwise the reverse of removal. Tighten all fasteners.

These are sold individually, so 1 per pack