Toyota 78180-60280 Cable Assy, Accelerator Control

You can Select Your Vehicle to check if 78180-60280 fits your vehicle.

To remove the accelerator cable, start by prying the cable end off the shaft using a small screwdriver. Then, loosen the accelerator cable locknut and remove the cable from the bracket assembly. Next, detach the screws and clips retaining the lower instrument trim panel on the driver's side and remove the trim piece. Pull the cable end out and up from the accelerator pedal recess. To disconnect the cable at the firewall, remove the cable retainer bracket bolts and push the cable assembly through the firewall from inside the passenger compartment. For installation, reverse the removal steps and ensure that flexible components are not routed within two inches of moving parts. Operate the accelerator pedal to check for any binding condition. Apply sealant around the accelerator cable at the engine compartment side of the firewall to prevent water from entering the passenger compartment if necessary. There is no specific adjustment for these types of accelerator cables, but it may be necessary to adjust the kick down cable for the automatic transmission.

To remove the throttle cable, start by disconnecting the cable from the negative terminal of the battery. Then, loosen the locknut on the throttle cable at the throttle body and remove the cable end from the slot in the lever. Next, detach the cable from the accelerator pedal by removing the bolts and sliding the cable end out of the slot in the housing. Remove the two bolts securing the cable casing to the firewall and pull the cable through from the engine compartment. For installation and adjustment, reverse the removal steps and ensure the cable casing grommet is properly seated in the firewall. To adjust the cable, fully depress the accelerator pedal and check that the throttle is fully opened. If not, loosen the locknuts, depress the pedal, and adjust the cable until the throttle is fully open. Finally, tighten the locknuts and verify that the throttle closes fully when the pedal is released.

78180-60280 goes to the gas pedal 35520-60111 is the kick down cable that goes to the transmission