Toyota 23217-0C010 Fuel Filter Pump

You can Select Your Vehicle to check if 23217-0C010 fits your vehicle.

This job should be done with the engine cold(after sitting at least three hours). Place a metal container, rags or newspapers under the filter to catch spilled fuel. Relieve the fuel system pressure. Unscrew the banjo bolts on both ends of the fuel filter (Remove the banjo fittings from the fuel filter). Disconnect both lines. The fuel filter on Tacoma and 4Runners is located under the chassis. Remove both bracket bolts and detach the old filter and the filter support bracket. Remove the filter clamp bolt and separate the old filter from the bracket. Note that the inlet and outlet lines are clearly labeled and that the flanged end of the filter faces down. Install the new filter and bracket assembly and tighten the bracket bolts securely. Make sure that the new filter is installed flanged end down. Using the new sealing washers - two per banjo fitting - provided by the filter manufacturer, install the inlet and outlet banjo bolts and tighten them to the specified torque. The remainder of installation is the reverse of the removal.