Toyota 90915-10004 Filter Sub-Assy, Oil

You can Select Your Vehicle to check if 90915-10004 fits your vehicle.

Add fresh oil through the oil filler cap, check the oil level on the dipstick, start the engine, and check for leaks. Wait for the oil to drain back into the pan and recheck the oil level on the dipstick.

Frequent oil changes are essential for a vehicle's engine because aging oil can become diluted and contaminated, which can lead to premature engine wear and damage.

Frequent oil changes are essential for preventive maintenance to prevent premature engine wear. Before starting the procedure, ensure you have all the necessary tools and materials. Park the vehicle on a level surface and let the engine reach its normal operating temperature. Remove the oil filler cap and raise the vehicle securely on jackstands. Familiarize yourself with the location of the oil drain plug and place a drain pan underneath. Carefully remove the drain plug, allowing the old oil to drain completely. Inspect the old oil for any metal shavings or chips. Wipe off the drain plug and clean the area around it before reinstalling it. Move the drain pan under the oil filter and loosen the filter using a filter wrench. Unscrew the filter by hand, being careful to prevent oil spillage. Wipe off the mounting surface on the block and ensure no residue or old gasket remains. Compare the old filter with the new one to ensure they are the same type. Lubricate the new filter's rubber gasket with engine oil and screw it into place by hand. Tighten it until the gasket contacts the seating surface and give it an additional 3/4-turn. Lower the vehicle. For certain engine models, additional steps may be required to remove and replace the oil filter housing. After completing the filter replacement, add fresh oil to the engine through the oil filler cap. Pour the appropriate amount of oil and wait for it to drain into the pan. Check the oil level using the dipstick and add more if necessary. Start the engine and check for leaks. After the oil change, it is important to check for leaks and proper oil level during the first few trips. Dispose of the old oil at an oil reclamation center or other designated facility. To reset the service reminder light, follow the specific instructions for your vehicle's trip meter or multi-informational system.

After replacing the oil filter, you should remove tools, lower the vehicle, add new oil through the filler cap (typically three quarts at first), wait, check the oil level with the dipstick, start the engine, and check for oil leaks.

After an oil change, check for leaks and proper oil level during the first few trips to ensure everything is functioning correctly. The old oil should be disposed of at an oil reclamation center or an appropriate disposal site.