Toyota 69260-89104-B1 Front Door Window Regulator Handle Assembly

Removal steps 1. Park on level ground, set the parking brake, wear eye protection and gloves. 2. If the door has wiring or an airbag, disconnect the negative battery cable before beginning and follow airbag-safety guidance; wait several minutes after disconnecting. 3. Lower or raise the glass as needed so the handle and its retaining fastener are accessible. 4. Inspect how the handle is retained-commonly a spring/U-clip, small set-screw, press-fit, or trim cap; choose the appropriate tool (trim tool, small flat screwdriver, pick, or handle puller). 5. Release the retaining device using the appropriate method (pry off cap, depress clip, loosen screw, or use a puller) while supporting the handle. 6. Pull the handle straight off the splined/shaft engagement once the fastener is released; avoid excessive twisting. 7. Remove and retain any clips, screws, or trim pieces and inspect splines/shaft for damage or corrosion. Installation steps 1. Clean splines/shaft and replace any damaged or worn retaining parts before assembly. 2. Position the retaining clip or screw on the shaft if required by the design, then align the handle splines with the shaft. 3. Slide or press the handle onto the shaft until the clip engages or the handle seats fully; if the design uses a screw, tighten it snugly by hand or tool (do not apply specified torques). 4. Reinstall any trim caps or covers. 5. Reconnect the negative battery cable if disconnected and restore any disabled systems, following airbag reconnection guidance if applicable. 6. Cycle the window fully and operate the handle to verify smooth operation, secure attachment, and correct alignment of trim. Repair tip 1. Protect door trim with a cloth when prying, and replace small spring clips rather than reusing fatigued ones for a more secure fit.