Toyota 17101-0A010 Manifold, Intake

You can Select Your Vehicle to check if 17101-0A010 fits your vehicle.

Checking for warpage and resurfacing the manifold is important to ensure a good fit and seal. This step is performed if the gasket was leaking.

Ground straps, the knock sensor, and intake manifold braces are disconnected. These components are removed to facilitate the removal of the intake manifold.

The fuel rail and injectors are removed as an assembly. The electronic throttle motor connector is disconnected, and the throttle body is removed. Additionally, PCV and vacuum hoses connected to the rear of the intake manifold are labeled and detached.

To remove the upper intake plenum, start by relieving the fuel system pressure and disconnecting the negative battery cable. Drain the coolant and remove the V-bank cover and air cleaner assembly. Disconnect the electrical connectors, vacuum and coolant bypass hoses from the throttle body, and disconnect the throttle motor connector. Remove the front suspension brace (if applicable) and unbolt the intake plenum braces at the rear cylinder head. Finally, remove the bolts and nuts holding the plenum to the lower intake manifold. To remove the lower intake manifold, disconnect the electrical connectors from the fuel injectors and detach the air assist and heater hoses. Remove the fuel line from the fuel rail and then remove the mounting bolts and nuts to detach the manifold from the engine. Replace the water transfer hose if necessary. For installation, clean the mating surfaces, install new gaskets, and position the manifold on the engine. Tighten the nuts/bolts in three or four equal steps. Finally, reinstall the remaining parts and refill the cooling system, checking for any leaks.

Scrape off old gasket material and clean the mating surfaces. Install new gaskets and position the manifold on the engine. Tighten the nuts/bolts.

Start by relieving the fuel system pressure and disconnecting the negative battery cable.