Toyota 87103-0E040 Motor Sub-Assy, Blower W/Fan

Disconnect the cable from the negative battery terminal. The blower unit is located in the passenger compartment above the right front foot well. Remove the glove compartment liner, the glove compartment door, and the right lower dash panel. To remove the blower, take out the blower unit retaining screws and lower the unit from the housing, noting that the blower motor is located under the right end of the instrument panel. If the motor is being replaced, transfer the fan to the new motor prior to installation by using pliers to release and remove the clip, then lift the blower fan off the motor shaft. Installation is the reverse of removal, and it is important to check for proper operation.

If equipped, the right lower dash panel (just below the glove box) should be removed. Additionally, on 2016 and later Lexus models, the passenger's side kick panel must be removed to allow for the removal of the lower dash panel.

No, this will only fit the US model cars

No, the one for a Japan model vehicle is a different part number.

Yes, this is specific for just the front side.

The resistor is already integrated into the part