Toyota 23870-0P011 Pipe Assembly, Fuel Deli

Release fuel pressure and disconnect the battery. Remove engine covers, cowl assembly, and air filter housing. Disconnect injector connectors and fuel line, then remove the fuel rail and injectors. Store them in a labeled container. If reusing injectors, replace grommets and O-rings. Remove the fuel rail and injectors as a unit. To reinstall, switch the removal steps going from the final step to the beginning step. Tighten the fuel rail bolts.

To remove and replace fuel injectors in a vehicle, start by relieving fuel pressure and disconnecting the negative battery terminal. Remove the engine cover and air intake duct if necessary. For four-cylinder models, disconnect electrical connectors, and remove the fuel supply line and fuel rail mounting bolts. Lift the fuel rail and injectors as a single assembly, replacing O-rings if necessary. For V6 models, remove the strut brace and intake manifold. Disconnect electrical connectors, and remove the Vacuum Switching Valve mounting bracket. If removing the entire fuel rail assembly, disconnect the fuel supply line and crossover tube. For 2GR-FKS V6 models port injection replacement, remove the upper intake manifold, and disconnect the fuel lines and electrical connectors. For direct injection, remove the upper intake manifold and high-pressure fuel pump. Install new injectors and O-rings, then reassemble components in reverse order. Start the engine and check for leaks.

To reinstall the fuel injectors, follow the reverse order of removal steps. Make sure to properly tighten the fuel rail mounting bolts.