Toyota 89413-06010 Sensor, Transmission

The sensors in the U250E 5-speed transaxle (2009 and earlier four-cylinder models) consist of two-speed sensors- one for the turbine (input) shaft on the front of the transaxle, and one for the counter gear (output) shaft located on top of the transaxle. When replacing the sensors in the U250E 5-speed transaxle, begin by unplugging the electrical connector. The next step would be to unscrew the sensor. Lastly, replace the O-ring On the other hand, the U660E/U760E 6-speed transaxles (all other models) have one speed sensor, which is inside the transaxle on top of the valve body. To replace the sensor, have a transmission specialist replace it as it needs the removal of the transaxle fluid pan, filter, and valve body due to the sensitivity of the valve body.

Complete the replacement process by following the removal steps in reverse order. This entails reattaching the speed sensor, securing the mounting bolt, connecting the electrical connector, and finalizing any other steps in the reverse sequence.

1. Disconnect the cable from the negative terminal of the battery. 2. Remove the air filter housing. 3. Disconnect the ABS electrical connector and unscrew the brake line fittings. 4. Remove any brackets securing the brake lines and unbolt the ABS actuator bracket. 5. Remove the actuator and bracket as one unit from the engine compartment.