Toyota 77001-20941 Tank Assy, Fuel

Carrying out this procedure is easier when the fuel tank is empty which can be done by unscrewing the fuel drain plug after taking off the fuel filler cap. Attempting to continue and use the vehicle, getting out of the way, waiting for the tank to be empty or siphoning the fuel into the approved container. The procedure begins with reducing fuel pressure and subsequently the separation of the cable from the negative terminal of the battery provided that the car stereo is equipped with an anti theft system. If the tank is full, it is recommended that using a hand-operated pump, draw as much fuel as one is able to through the filler tube. Chock the wheels and then lift the Beretta using a jack until it's just beneath the fuel tank so that you can place some plank to avoid direct contact with fuel. Pull out the fuel line bracket and undo the fuel line or tank pre-titters then loosen and fold the two fuel tank bands aside. Lower the tank enough to have access to theses wires and ground strap to the fuel pump/fuel gauge sending unit. Pull the fuel lines and cutoff the fuel inlet pipe as well as the vapor return line; if you need to reinstall them, try to label them first. Last of all, undo the spoiling of the tank from the vehicle and reattach it in the same manner but in the reverse manner.

Be especially careful inside garages where a natural gas-type appliance is located, because the pilot light could cause an explosion.