For the 2009 and the models before it, remove the mirror cover by unscrewing the small retainers in the door and then pulling the electrical connector off then detaching the three nuts bolting the mirror, and pulling off the mirror Before installing the mirroring, the process will be the same as the removal process. For 2010 + models, the procedure starts with the removing of the door trim panel, followed by the unscrewing of the mirror shield screw and popping it loose. After this pry off the mirror hole cover which is located from inside of the door; the door panel should be removed for the disconnected mirror wiring. It is then necessary to depower the mirror by unplugging some wires, undoing three hex head bolts, and pulling the mirror assembly up and out; this process is also the opposite of the installation process.