Genuine Toyota Avalon Camshaft Position Sensor

Toyota Avalon Camshaft Position Sensor Parts Questions & Answers

• Sensor, Crank Position
  90080-19014
  Q: How to check and replace the camshaft position sensor?

  A: The camshaft position sensor affects the position for constant fuel injection in each cylinder. On four-cylinder engines, it is on the back of the cylinder head, while V6 engines have it on the front. If there is a problem with the camshaft sensor circuits, it will send a diagnostic trouble code. To check the camshaft sensor, begin by disconnecting the electrical connector at the sensor. Use an ohmmeter to probe the two terminals. For camshaft sensor replacement, ensure the ignition key is in the OFF position. Disconnect the harness connector, remove the mounting screws, and proceed to remove the camshaft sensor from the cylinder head.
• Sensor, Crank Position
  90919-05060
  Q: What are the instructions for removing and installing CMP and VVT sensors on Toyota Camry and Toyota Avalon?

  A: Camshaft Position Sensor are utilized on four-cylinder models, while VVT sensors are utilized on V6 engine models. For 2009 and earlier models, the sensor is located on the left side of the cylinder head below the valve cover. To remove, begin by removing the air filter housing, followed by disconnecting the electrical connector. Unbolt the sensor and remove. Installation is the reverse of removal. For 2010 and later models, the sensor(s) are mounted on the top of the valve cover. To remove them, the harness electrical connector needs to be disconnected, followed by removing the mounting screws and taking out the camshaft sensor(s) from the valve cover. Installation is the reverse of removal.