Genuine Toyota Solara Coolant Reservoir

Toyota Solara Coolant Reservoir Parts Questions & Answers

• Tank Assy, Radiator Reserve
  16470-03081
  Q: How do you remove and install a radiator and coolant reservoir on 1997 through 2001 Toyota Avalon and 1997 through 2001 Toyota Solara?

  A: To remove the radiator, start by disconnecting the negative battery cable and draining the coolant into a container. Remove the upper and lower radiator hoses, as well as the reservoir hose from the radiator filler neck. If there is a Cooling Fan Assembly, remove it. For vehicles with an automatic transaxle, disconnect the cooler lines from the radiator, placing a drip pan beneath to catch any fluid. Remove the bolts that attach the radiator to its support and carefully lift out the radiator, being cautious of any dripping fluids and sharp fins. Inspect the radiator for leaks, damage, and blockage. Clean off bugs and dirt using compressed air and a soft brush. For installation, reverse the removal procedure and ensure the rubber mounts are in place. Fill the cooling system with the appropriate mixture of antifreeze and water. Check for leaks, allow the engine to reach normal operating temperature, and recheck the coolant level. For coolant reservoir removal, typically remove one bolt and pull the reservoir up and out of the bracket on the fender well. Inspect for damage and replace if necessary. Installation is the reverse of the removal process.
• Tank Assy, Radiator Reserve
  16470-AA020
  Q: How to remove and install a radiator and coolant reservoir on 2002 through 2008 Toyota Solara and 2002 through 2006 Toyota Avalon?

  A: To remove the radiator, disconnect the battery, drain the coolant, and detach the hoses. If there's an automatic transaxle, disconnect cooler lines and collect the fluid. Install the radiator, ensuring rubber mounts are in place. Fill with antifreeze and water, start the engine, and check for leaks. Recheck the coolant level and add if needed. Check and add fluid for automatic transmission models. To remove the coolant reservoir, pull it out, pour the coolant into a container, and inspect for damage. Replace if necessary. Installation is the reverse of removal.