Loosen the front wheel lug nuts, raise the vehicle, support it securely on jackstands, and remove the front wheel. Open the hood and remove the front bumper cover. Next, take out the headlight housing and the inner fender splash shield fasteners, then remove the shield. For models with trim molding around the wheel opening and rocker panels, remove the trim by locating and taking out screws or bolts along the bottom edge, using a flat tool wrapped in tape to pry it away carefully. Remove the mounting fasteners at the front of the fender, and if removing the passenger side fender, take out the radio antenna. Working inside the inner fenderwell, remove the fasteners securing the fender to the body, then open the front door to remove the lining fastener near the top and pull the lining back enough to access the upper fender-to-body fastener. Remove the fender upper mounting fasteners and lift off the fender, ideally with assistance to prevent damage to surrounding body panels. Installation is the reverse of removal, ensuring to check the alignment of the fender to the hood and front edge of the door before final tightening of the fender fasteners.