Toyota 90981-13044 Bulb

Depending on the make and model, some of these vehicles come with Halogen or LED type of headlamps For the information on how to replace the bulb applies to the Halogen type only. For a bulb on the right side or the rear, the plastic retainer has to be first removed and the windshield washer fluid reservoir neck moved out of the way. First, they placed a call for performance that included not only a degree of output above the base model but also a design enhancer for a low-beam bulb replacement where all one has to do is unscrew the weather sealing cap at the base which is counterclockwise. Subsequently, depower and remove the electrical connector therein which the tab is lifted prior to disconnecting. Make sure to get a good grip on the bulb holder providing that twist it in a leftwards direction to release it from the housing. Carefully twist a new bulb assembly installed into the headlight housing without coming into contact with the glass with bare hands and turn it to bring its tabs with the cutouts. Last but not the least, reconnect the electrical plug and if a low-beam bulb has been replaced, replace the weather sealing cap.

Turn the steering wheel to give the best access to the front of the wheel arch.

The inner headlight bulbs are the high-beam bulbs, while the outer bulbs are the low-beam bulbs. The low-beam bulbs are also illuminated when the high-beam bulbs are turned on.

When installing the new bulb, make sure that the three lugs on the mounting base of the bulb socket are aligned with their corresponding cutouts in the headlight housing. Then, insert the bulb socket into the housing and turn it clockwise until it stops.

Depress the release tab and pull off the connector.

Depress the release tab and disconnect the electrical connector from the high-beam headlight bulb socket.

Installation is the reverse of removal.

The inner headlight bulbs are the high-beam bulbs and the outer bulbs are the low-beam bulbs.

Remove the instrument cluster and rotate the bulb counterclockwise to remove it.

Open the hood and reach behind the headlight assembly to unplug the electrical connector by depressing the clip on the harness connector.

Reach behind the headlight assembly and rotate the bulb holder counterclockwise to remove the bulb.

Remove the bulb holder retainer.

Plug in the electrical connector and insert the new bulb assembly into the headlight housing, twisting it clockwise to lock it in place.

Depress the release tab and pull off the connector.

Always check the bulb contacts and holder to ensure there is clean metal-to-metal contact between the bulb and its live(s) and earth. Clean off any corrosion or dirt before fitting a new bulb.

1. Detach the dome light lens. 2. Grasp the bulb securely and detach it from the spring clips at each end. 3. Installation is the reverse of removal.

Release the spring clip to remove the bulb holder.

Remove the rubber cover over the bulb, then release the spring securing the headlight bulb and remove the bulb.

Remove the lower engine splash shield.

Installation is the reverse of removal.

Installation is the reverse of removal.

Always ensure that the new bulb is of the correct rating and that it is completely clean before fitting it, especially for headlight/foglight bulbs.

Unhook the wire retaining clip sideways at the top, then pivot the clip down.