Toyota 78180-02290 Cable Assy, Accelerator Control

You can Select Your Vehicle to check if 78180-02290 fits your vehicle.

2005 and later models do not have an accelerator cable. Instead, the throttle body has an electric motor that operates the throttle and is controlled by the PCM. 2003 and 2004 models with cruise control have two accelerator cables - one from the accelerator pedal to the cruise control actuator and one from the cruise control actuator to the throttle body. To remove, disconnect the cable from the negative terminal of the battery. On models with cruise control, remove the cover from the cruise control actuator. Loosen the locknut on the threaded portion of the throttle cable at the throttle body or cruise control actuator. Rotate the throttle lever or cruise control actuator and slip the throttle cable end out of the slot in the lever. Detach the throttle cable from the accelerator pedal. Remove the two bolts securing the cable retainer to the firewall. From inside the vehicle, pull the cable through the firewall. To install and adjust, installation is the reverse of removal. Make sure the cable casing grommet seats properly in the firewall. To adjust the cable, fully depress the accelerator pedal and check that the throttle is fully opened. If not fully opened, loosen the locknuts, depress the accelerator pedal, and adjust the cable until the throttle is fully open. Tighten the locknuts and recheck the adjustment. Make sure the throttle closes fully when the pedal is released.

2005 and later models do not have an accelerator cable. Instead, the throttle body has an electric motor that operates the throttle and is controlled by the PCM. Models with cruise control have two accelerator cables - one from the accelerator pedal to the cruise control actuator and one from the cruise control actuator to the throttle body. To remove, detach the cable from the negative terminal of the battery. On models with cruise control, remove the cover from the cruise control actuator. Loosen the locknut on the threaded portion of the throttle cable at the throttle body or cruise control actuator. Rotate the throttle lever or cruise control actuator and slip the throttle cable end out of the slot in the lever. Detach the throttle cable from the accelerator pedal. Remove the two bolts securing the cable retainer to the firewall. From inside the vehicle, pull the cable through the firewall. To install and adjust, installation is the reverse of removal. Make sure the cable casing grommet seats properly in the firewall. To adjust the cable, fully depress the accelerator pedal and check that the throttle is fully opened. If not fully opened, loosen the locknuts, depress the accelerator pedal, and adjust the cable until the throttle is fully open. Tighten the locknuts and recheck the adjustment. Make sure the throttle closes fully when the pedal is released.