Toyota 35520-60050 Cable Assembly, Throttle

You can Select Your Vehicle to check if 35520-60050 fits your vehicle.

The first step is to detach the cable from the negative terminal of the battery.

To remove the accelerator cable, start by prying the cable end off the shaft using a small screwdriver. Then, loosen the accelerator cable locknut and remove the cable from the bracket assembly. Next, detach the screws and clips retaining the lower instrument trim panel on the driver's side and remove the trim piece. Pull the cable end out and up from the accelerator pedal recess. To disconnect the cable at the firewall, remove the cable retainer bracket bolts and push the cable assembly through the firewall from inside the passenger compartment. For installation, reverse the removal steps and ensure that flexible components are not routed within two inches of moving parts. Operate the accelerator pedal to check for any binding condition. Apply sealant around the accelerator cable at the engine compartment side of the firewall to prevent water from entering the passenger compartment if necessary. There is no specific adjustment for these types of accelerator cables, but it may be necessary to adjust the kick down cable for the automatic transmission.