Toyota 69052-02080 Door Lock Cylinder & Key Set Left Hand

Remove the door trim panel and the plastic water shield. Reach inside the door and disconnect the control links from the latch. Remove the latch retaining screws from the end of the door and detach the door latch along with the door lock solenoid if equipped. Installation follows the reverse order of removal. Working through the access holes in the door, disconnect the control rods from the lock cylinder and outside handle. Loosen the screw with a Tone bit and pull the lock cover and lock cylinder from the outside of the door. To remove the outside handle, disconnect the control rod and remove the two mounting screws inside the door. If replacing the outside handle assembly, disconnect the rod and door operating cable from the handle assembly and transfer them to the new handle. Use a screwdriver to pry the retaining clip off or remove the lock cylinder retaining bolt and take out the lock cylinder from the handle, with installation being the reverse of removal. Remove the retaining screw and pull the handle free, disconnecting the cables from the inside handle control before removing the handle from the door. Installation is again the reverse of removal.