Toyota 85330-20470 Motor And Pump Assy, Windshield Washer

For the removal of the washer fluid reservoir, it is first necessary to take out the front bumper as well as the driver's side headlight. Remove the wiring plug of the washer pump you also expect some leakage when you are doing this exercise so make sure you have a suitable receptacle. Removing the washer hoses, make a note of the hose fits to the car; removing the reservoir attachment bolts and carefully lifting the reservoir upward to free its pegs on inner car guard-be careful, do not damage the filler neck. For refitting reverse the removal procedure and make update the washer hoses are properly connected or reattached. To delete the washer fluid pump, pry from the reservoir and save the rubber sealing grommet for the pump that accompanies it. Inspect the grommet and replace if worn out before reattaching the pump without forcing the grommet into the reservoir, and making sure the fluid hoses are connected again. For the windscreen washer jet, remove the Bug from the outside of the bonnet while avoiding to scratch the paint and remove the washer hose, then fix it to the bonnet to avoid it falling inside. Refitting entails the reversal of removal processes while making certain that the fluid hose connectors are properly connected. To prevent the fluid coming out, for the tailgate washer jet, you should disconnect the fluid hose from the bottom of the jet with expectations of the fluid dripping, and put a piece of tape around the hose to secure it to the tailgate, and in addition, you have to take out the high-level stoplight. To remove, gently lever the washer jet upwards out of the top of the tailgate and when reinstalling reverse this process and make sure that the fluid hose is properly connected.