Toyota 04465-08030 Front Disc Brake Pad Kit

Remove the cap from the brake fluid reservoir, then loosen the wheel lug nuts, raise the front or rear of the vehicle, and support it securely on jackstands while blocking the wheels at the opposite end. Remove the wheels and work on one brake assembly at a time, using the assembled brake for reference if necessary. Inspect the brake disc carefully; if machining is necessary, remove the disc to also take out the pads. Push the piston back into its bore to create space for the new brake pads, using a C-clamp for this task, and ensure the fluid in the master cylinder does not overflow, siphoning off some if needed. When replacing the front brake pads, wash the brakes with brake cleaner before disassembly, and maintain order while reading the captions under each illustration. When removing the caliper mounting bolts, use a second wrench to hold the hex on the sliding pin. Upon reinstalling the caliper, tighten the mounting bolts to the specified torque, then firmly depress the brake pedal a few times to bring the pads into contact with the disc. Finally, check the brake fluid level and add if necessary, ensuring the brakes operate correctly before returning the vehicle to normal service.

The application of this procedure is on both the front and rear disc brakes and depending on the pads selected, pad shims and wear indicators should be renewed each time with the pads. It is advisable to start by unscrewing the cap on the brake fluid container. Typically, loosen the wheel lug nuts, raise the front or rear part of the automobile and place it on jack stands and block the wheels at the other end. Take off the wheels and carry out servicing one brake assembly at the time, referring to the assembled brake if necessary. Examine the brake disc; if it needs to be machined, pull out the disc to also get rid of the pads. Pull the piston back into the bore to clear space for the new brake pads, here a C-clamp is used while exercising caution so that you do not spill too much of the hydraulic fluid in the master cylinder, siphoning some off if it gets to be too much. For front brake pad replacement, in the following illustrations will be shown in order and for the rear brake pad replacement, the brake assembly should be cleaned using brake cleaner before removing the parts. When reinstalling the caliper, torque the mounting bolts to the prescribed value. Lastly, a few applications of the brake pedal after the job to ensure a contact between the pads and the disc is made and inspection of the brake fluid level with subsequent addition of some of the fluid, if needed, and testing for the proper working of brakes before putting the vehicle back to normal usage.

04465-08030 IS OEM 04465-AZ006 IS A VALUE LINE EITHER WILL WORK

These have 4 pads, a complete set for the front 2 wheels

No, the shims will need to be reused if still in good condition