Toyota 16100-69398 Engine Water Pump Assembly

A failure in the water pump can cause serious engine damage due to overheating. With the engine running and warmed to normal operating temperature, squeeze the upper radiator hose. If the water pump is working properly, a pressure surge should be felt as the hose is released. Water pumps are equipped with weep or vent holes. If a failure occurs in the pump seal, coolant will leak from this hole. In most cases it will be necessary to use a flashlight to find the hole on the water pump by looking through the space behind the pulley just below the water pump shaft. If the water pump shaft bearings fail there may be a howling sound at the front of the engine while it is running. Bearing wear can be felt if the water pump pulley is rocked up and down. Do not mistake drivebelt slippage, which causes a squealing sound, for water pump failure. Spray automotive drivebelt dressing on the belts to eliminate the belt as a possible cause of the noise.

1. Installation is the reverse of removal.2. Apply a 3 mm bead of ATV sealant to the water pump.3. Tighten the water pump bolts to the torque.4. Refill the cooling system, run the engine, and check for leaks.