Toyota 90080-31033 Seal, Engine Rear Oil

You can Select Your Vehicle to check if 90080-31033 fits your vehicle.

The transaxle must be removed from the vehicle.

The bolts should be tightened gradually.

Drive it into place using a socket or a short section of large diameter pipe.

To remove the crankshaft oil seal, start by removing the timing belt and crankshaft timing belt sprocket. Cut away the seal lip with a razor knife and carefully pry the seal out of the engine using a screwdriver or seal removal tool. Clean the bore and coat the outer edge of the new seal with engine oil or multi-purpose grease, then drive the new seal into place using a seal driver or a socket with a slightly smaller outside diameter. Make sure it's installed squarely and to the same depth as the original. Reinstall the crankshaft timing sprocket and timing belt, being careful not to scratch the crankshaft sensor portion. Run the engine and check for oil leaks at the front seal. To remove the camshaft oil seals, start by removing the timing belt and camshaft sprocket(s). Remove the bolts and detach the rear timing belt cover. Carefully pry out the seal using a screwdriver wrapped with tape to avoid scratching the bore or damaging the camshaft. Clean the bore and coat the outer edge of the new seal with engine oil or multi-purpose grease, then drive the new seal into place using a seal driver or a socket with a slightly smaller outside diameter. Make sure it's installed squarely and to the same depth as the original. Reinstall the rear timing belt cover and tighten the bolts. Reinstall the camshaft sprocket(s) and timing belt. Run the engine and check for oil leaks at the camshaft seal.