Toyota 84872-02060 Outer Mirror Switch Assembly

To start, detach the negative battery cable. Detach the electrical connection to the hazard warning switch from the instrument panel's center cluster by removing the panel while pulling out the whole assembly. Press the tab and pull out the hazard warning switch from the pocket, and reverse this process to put it back in place. Unscrew and detach the small panel where the power mirror control switch is. Use your trim tool to remove the panel and disconnect the switch cable; slide the switch out and reverse the process to put it back together. Find the rear defogger switch at the back of the heating and air conditioning roadster control panel. Pull the panel forward to disconnect the electrical connector at the switch's back. Press the tab and then carefully remove the switch from the bezel. Installing it is the opposite of how to remove it, only in reversed steps. Turn off the instrument panel lights from the driver's vent bezel. Use a tape-on screwdriver or tool to lift the trim panel, detach the electrical connector, and unclip the switch. Putting it all back works like taking parts out.