To remove the Clutch Slave Cylinder you will have to disconnect the negative terminal from the battery, then safely lift the car and put it on jackstands. Then, shut off the hydraulic line at the Clutch Slave Cylinder employing the flare-nut wrench, in order not to round off the fitting, and put a small can plus some rags in case the hydraulic fluid spills. Subsequently, take out the Clutch Slave Cylinder mounting bolts and then the Clutch Slave Cylinder. For installation, first position the Clutch Slave Cylinder over the clutch housing and align the pushrod to sit in the release fork pocket; then finalize the hydraulic line connection to the cylinder and this connection should be secure. Add the correct brake fluid in the brake master cylinder and also the brake system should be bled before the vehicle is lowered and the negative cable of the battery should be connected again.