My Garage
My Account
Cart
Genuine Toyota MR2 Hood
Engine Hood- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
3 Hoods found
Toyota MR2 Hood
The mid engine bay of the Toyota MR2 Hood is protected from flying road debris while allowing the driver to access vital components quickly. The body of this Toyota sports car gets chipped from constant exposure to gravel, stones, and harsh weather conditions. Continued impact to the front end can bend the panel in seconds. By keeping the panel undamaged, looks and safety are preserved. On the inside, hinges, release cables, and springs allow the Hood to open and close smoothly, whereas gas shocks or struts keep the Hood up high so routine inspections can be done hands-free. When those little parts wear out, the Hood will not open or droop unexpectedly, meaning simple maintenance is not so simple. Over the years, the model line has relied on sturdy steel construction as this crumples to absorb crash energy in an accident, thus protecting the occupants. Whether you have an early MR2 or the final third generation MR2 roadster, a new Hood restores the sporty profile and keeps your Toyota looking sharp and running dependably.
If you are in demand for superior quality and affordable OEM Toyota MR2 Hood, then shop with us! We own a wide range of the reduced-priced genuine Toyota MR2 Hood. You can purchase in confidence as all parts come with a manufacturer's warranty. Any issues with our products? No need to worry as we have a hassle-free return policy to guide you every step of the way.
Toyota MR2 Hood Parts Questions & Experts Answers
- Q: How to remove, install, and adjust the front Hood on Toyota MR2?A:To remove the hood, first disconnect the windshield washer line at the washer reservoir. Next, scribe or paint alignment marks along the edges of the hood hinge upper flange and remove the hinge-to-hood mounting bolts before taking off the hood. For installation, position the hood, align the previously made marks, replace the upper hinge-to-hood mounting bolts, and tighten them, then reconnect the windshield washer line. For adjustment, loosen the hood side hinge bolts to shift the hood in the desired forward/rearward and left/right directions, noting that centering bolts cannot be adjusted in place; substitute bolts with washers for this purpose. Adjust the front edge of the hood up or down by turning the cushions, and modify the rear edge by increasing or decreasing the number of shims on the hinge-to-body mounting bolts.
