Genuine Toyota Solara Oxygen Sensor

Toyota Solara Oxygen Sensor Parts Questions & Answers

• Oxygen Sensor
  89465-06010
  Q: What Is the Role of Oxygen Sensors and Air/Fuel Sensors in OBD-II Engine Management Systems and How Do They Function in Toyota Solara and Toyota Avalon?

  A: First off, all vehicles are equipped with On-Board Diagnostics II (OBD-II) engine management systems that include oxygen sensors and air/fuel sensors to verify the accuracy of the feedback loop between the oxygen sensor and the PCM. These sensors are placed before and after the catalytic converter to help control the efficiency of the converter. In fact, Camry models with four-cylinder engines have one oxygen sensor and one air/fuel sensor, while V6 engines have three sensors. Also, the main sensors are located in the exhaust manifolds, while the secondary sensor is placed after the catalytic converter. It is also important to note that the oxygen sensors monitor the oxygen in the exhaust stream to determine the air-to-fuel ratio, while the air/fuel sensors send feedback about alterations. Also, proper operating temperature, electrical connections, outside air supply, and use of unleaded fuel are important for the sensors. Finally, the silicone boot must be installed carefully to prevent damage and ensure proper function.
• Air Fuel Ratio Oxygen Sensor
  89467-33040
  Q: How to Check and Replace Oxygen and Air/Fuel Sensors in Toyota Solara and 1997 through 2001 Toyota Avalon?

  A: To check the oxygen sensor, locate the electrical connector and insert pins into the signal and ground terminals, then use a voltmeter to monitor the voltage signal as the engine warms up. The sensor should fluctuate between 0.1 to 0.9 volts in closed-loop mode. Inspect the heater resistance and verify it is receiving battery voltage. If the sensor fails any tests, replace it. To replace the sensor, disconnect the battery, unplug the electrical connector, unscrew the sensor from the exhaust manifold, apply an anti-seize compound to the threads, and install the new sensor. The air/fuel sensor cannot be checked for voltage without a special tool, but the resistance of the heating element can be checked with an ohmmeter. To replace the AF sensor, disconnect the battery, unplug the electrical connector, unscrew the sensor from the exhaust manifold, apply anti-seize compound to the threads, and install the new sensor.