Detach the cable from the negative terminal of the battery, ensuring you have the correct activation code for the anti-theft system if applicable. Loosen the locknut on the threaded portion of the throttle cable at the 
Throttle Body. Rotate the throttle lever and slip the throttle cable end out of the slot in the lever. Detach the throttle cable from the accelerator pedal and remove the two bolts securing the cable casing to the firewall. From inside the engine compartment, pull the cable through the firewall. For installation, reverse the removal steps, ensuring the cable casing grommet seats properly in the firewall. To adjust the cable, fully depress the accelerator pedal and check that the throttle is fully opened; if not, loosen the locknuts, depress the accelerator pedal, and adjust the cable until the throttle is fully open. Tighten the locknuts and recheck the adjustment, confirming that the throttle closes fully when the pedal is released.