Toyota 52119-35901 Bumper Cover

To replace the front bumper, start by applying the parking brake, lifting the vehicle and supporting it by jack stands. Locate and take off the lower splash shield and the screws or bolts that hold the front part of the inner fender splash shields. Subsequently, the fasteners around the upper part of the bumper cover should be removed, followed by the middle and lower ones. Gently pop the cover outwards and if present, remove the connectors for the fog lights next, in order to release the cover from the car. To reinstall just undo the measures listed above and make sure that the tabs on the back of the bumper cover are locked into the appropriate clips belonging to the body, then, tighten bolts and screws, preferably when being assisted. Regarding the rear bumper, first, it is necessary to uninstall the rear mud flaps and then the upper bolts located at the rear wheelwell that fix the edge panel of the bumper cover. At the bottom, unscrew the fasteners on the lift gate and open it to uncover fasteners on the interior border of the bumper cover. Last, while removing the bumper cover, pull it out and backward, whereas the installation process is in the opposite of the removal process.