Toyota 69052-04020 Cylinder & Key Set, Door Lock, LH

To remove the door latch, start by raising the window and removing the door trim panel and watershield. Through the large access hole, disengage the rod to the outside handle and lock cylinder. Remove the plastic clips attaching the door lock rod. Then, remove the screws securing the latch to the door and disconnect the electrical connector. Pull the latch back and remove it through the door opening with the two cables from the inside door handle still attached. To remove the door lock cylinder, raise the window and remove the door trim panel and watershield. Remove the access plug at the rear of the door and loosen the TORX screw through the access hole. Remove the lock cylinder cover and the door lock key cylinder as a unit. Disengage the lock cover clips and separate the cover from the lock cylinder. To remove the outside handle, slide the exterior handle rearward and out. To remove the outside handle assembly, remove the handle assembly exterior mounting screw from the outside of the door. From inside the door, disconnect the electrical connector, remove the mounting screw, and disconnect the lock rod clip. Disengage the door handle assembly mounting clips and remove the handle assembly from the vehicle.

Raise the window, then remove the door trim panel and watershield. Working through the large access hole, disengage the rod from the handle, noting that all door lock rods are attached by plastic clips which can be removed by unsnapping the portion engaging the connecting rod and pulling the rod out of its locating hole. Remove the door lock cylinder, disconnect the electrical connectors at the latch, and remove the screws securing the latch to the door before taking out the latch assembly through the door opening. Installation is the reverse of removal. To access the outside handle and door lock cylinder, remove the plug from the end of the door and the lock cylinder retaining screw, then withdraw the lock cylinder from the door. Remove the mounting fastener for the handle from the inside of the door and take out the handle frame, with installation being the reverse of removal. For the inside door handle, release the lever retainers to disengage it from the door, disengage the lever-to-latch cables, and remove the lever, with installation again being the reverse of removal.