Toyota 81105-90A02 Driver Side Headlamp Housing Sub-Assembly

Remove the headlight bulb, then take off the radiator grille, side marker light, and the headlight trim bezel. Next, remove the retaining bolts, detach the housing, and withdraw it from the vehicle. Installation is the reverse of removal.

Disconnect the negative cable from the battery, ensuring you have the correct activation code for the stereo if it has an anti-theft system. Remove the headlight trim bezel and the turn signal assembly on FJ62 models. When replacing a headlight, avoid turning the spring-loaded adjusting screws to maintain the aim. Remove the screws securing the retaining ring and withdraw it while supporting the light. Pull the headlight out slightly and disconnect the electrical connector, then remove the light from the vehicle. Position the new unit to connect the electrical connector, ensuring the numbers molded into the lens are at the top. Install the retaining ring with its mounting screws and spring, then check the headlights for proper operation and adjustment; if the adjusting screws were not altered, no adjustment is needed. Install the radiator grille. For halogen bulb types, reach behind the headlight assembly to unplug the electrical connector, grasp the bulb holder securely, and rotate it counterclockwise to remove it from the housing. Pull straight out on the bulb to remove it from the bulb holder, and without touching the glass, insert the new bulb assembly into the headlight housing. Finally, plug in the electrical connector, test headlight operation, and close the hood.