Toyota 86160-04130 Speaker Assembly, Front

To remove the radio first, there is a necessity to unplug the cable from negative terminal, second it is necessary to remove heater and air conditioning control assembly. Next, remove the radio mounting bracket bolts and , jointly with the radio and brackets, remove the antenna lead and electrical connector. If it is being replaced by a new radio, relocate the left and right mounting brackets to the new radio. During installation of the new radio, the five locator pins of the radio assembly should engage into the respective holes of the instrument panel with installation is the reversal of the removal process. For door speakers, unscrew the door trim panel; there is a tab located at the back of the connector that needs to be pushed for the connector to be disconnected; after successfully disconnecting the electrical connector, there are three bolts located at the back that need to be unscrewed to be able to take out the speaker. The installation process on the other hand is in the opposite order. For door tweeters also, in addition to the above, you have to pop off the door trim panel, use a flat-head screwdriver to depress the tweeter electrical connector release tab, and then remove the two tweeter mounting bolts. Once again it is pertinent to note that, installation process is the reverse of removal process.