To remove the switch, unbolt the negative terminal of the battery and also engage the transaxle into Neutral. Subtract the nut and take off the shift lever and disconnect the electrical connector. Next, undo the attaching bolts with the help of a wrench and slightly lift the switch off the shift shaft. To install, the flats of the shift shaft must be slid into the corresponding notches in the switch and then push the switch onto the shaft. Place the bolts in a loosely manner and then go ahead with the adjustment. There are two methods to adjust the Neutral start switch: One of them, for example, requires the disconnection of the electrical connector, the loosening of the mounting bolts on the switch, and the measurement of the switch's continuity with an ohmmeter after rotating the switch; when correct continuity is obtained between the terminals, this means the switch is in the Neutral position, and the mounting bolts should be tightened securely. The second one applies the use of a switch which should be rotated until the neutral basic line on the switch housing matches the groove of the shift shaft and then the bolts are tightened.