There resides the turn signal/hazard flasher beneath the in-dash fuse and relay box's backside. Start with the removal of cable from the negative terminal of the battery and then start removing the knee bolster trim panel. Subsequently, there are drawers in the car, which can be opened by pulling down a bracket with a bolt and two nuts for removing the in-dash fuse and relay box in order to get access to its back part. Pull the turn signal/hazard flasher unit out of the in-dash fuse and the relay box by holding its body and yanking it horizontally. See that the new one is as same as the old one in all aspects before using the new one to replace the old one. Last but not least, installation can be described as the process that is the opposite of removal.